Wheat straw balers in the course of the operation needs to pay attention to what the problem is a technical point, the driver should be familiar with the driving skill. When the job, should be centered driving, avoid bundling the bulk of the phenomenon occurs. 2, tied belay Pulling outer structure and the knot less, high strength, to prevent broken rope or Kasheng. 3, to send the rope to steady throttle, keep the throttle speed to ensure quality delivery rope. 4, to send the rope stops, hydraulic valves must move immediately, do not stop, so as not to rub loose bale is pressed roller. Bundles should not slow down when put to bale released by rotational inertia. Third, one should pay attention to the issue, balers before use, be sure to make the necessary adjustments, including: roping agencies, pickup height, pick up and feed roller gap, the chain tightness, bale tightness adjustment and other parts, check all parts functioning properly, if unusual, should be shut down for maintenance. 2, when the baler and tractor hydraulic hydraulic pipe connected to the output, check the hydraulic lines for leaks, and plug the pipe ban in the case of hydraulic tubing pressure. 3, balers in use, is strictly prohibited pickup Tine harrowing, to observe the baler working conditions prompt, press the provisions of the operating manual, paying particular attention to the matter: bale reaches the set requirements, must immediately Vehicle halt, while controlling the throttle remains unchanged, so that the power output shaft continues to rotate, make bale tying, bundling after work is completed, balers open the back door to remove the bale forming chamber, complete baling operation. 4, balers encounter congestion when the job is to turn off the engine, cut off the power and then cleared. When unloading grass balers, forbidden to stand back to avoid crushing or bruising. 5, balers during maintenance, must be cut engine power output. 6, tractor baler driving on the road, pay attention to traffic safety, ensure that the power output is cut off. 7, due to start operating unskilled machine hand, efficiency of design requirements. Sometimes bundled quality is not guaranteed, appear broken rope or blockage situation.